 |
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
| Datasheet File OCR Text: |
| APLUS MAKE YOUR PRODUCTION A-PLUS ASM0406C DATA SHEET APLUS INTEGRATED CIRCUITS INC. Sales E-mail: Mr. Jason sales@aplusinc.com.tw Technology E-mail: Mr. George service@aplusinc.com.tw Address: 3 F-10, No. 32, Sec. 1, Chenggung Rd., Taipei, Taiwan 115, R.O.C. (115) 32 3 10. TEL: 886-2-2782-9266 FAX: 886-2-2782-9255 WEBSITE : http: //www.aplusinc.com.tw ASM0406C ASM0406C - VERY LOW-COST VOICE SYNTHESIZER WITH 4-BIT MICROPROCESSOR 1.0 General Description The ASM0406C is very low cost voice synthesizer with 4-bit microprocessor. It has various features including 4-bit ALU, ROM, RAM, I/O ports, timers, clock generator, watchdog timer(WDT), voice synthesizer, etc. It consists of 22 instructions in the device. With CMOS technology and halt function can minimize power dissipation. Its architecture is similar to RISC, with two stages of instruction pipeline. It allows all instructions to be executed in a single cycle, except for program branches and data table read instructions (which need two instruction cycles). 1.1 Feature Single power supply can operate from 2.4V through 5V Internal Program ROM: 4K x 10-bit 1 sets of 15-bit DPR can access up to 16K x 10 bits data memory space Data Registers: * 64 x 4-bit data RAM (00-1Fh plus 40h-5Fh) * Unbanked special function registers (SFR) range: 20h-3Fh I/O Ports: * PRA: 4-bit I/O Port A (2Bh) * PRB: 2-bit Output Port B (2Dh) On-chip clock generator: Resistive Clock Drive(RM) Timer: 1 * Timer0: a 9-bit auto-reload timer/counter Stack: 2-level subroutine nesting HALT and Release from HALT function to reduce power consumption Watch Dog Timer (WDT) Instruction: 1-cycle instruction except for table read and program branches which are 2-cycles Number of instruction: 22 The Voice function can be implemented by microprocessor instruction * One 8-bit COUT output for ASMxxxxx 1 ASM0406C FIGURE 1.1 : Block Diagram of ASM0406C Data Bus[3:0] ROM Latch PCL(4) PC[11:0] (ADDR[14:12]) =000b ADDR[14:0] Stack(12) (2-Level) 0 ROM_ADDR[14:0] 1 DPR3,2,1 DPR[14:0] Program (Data) ROM Instruction Latch Instruction Bus [9:0] Instruction Decoder PCLATCH(8) PCH(8) DLATCH(10) ROM_Data[9:0] Data Bus[3:0] Accumlator(4) Instruction Bus [9:0] SRAM ALU(4) Register(4) Immediate(4) (64 x 4) 00h-1Fh 40h-5Fh Timer0(9) PRA(4) PRB(2) P1,P2,P3,P4 enter test mode ( Voice synthesizer ) Clock Generator Test select Power on Reset RESET pin PRA0 weak or strong pull-low for PRA, PRB, PRC OSC VDD/GND PRASL(4) One-Channel Reset Chip Reset Chip COUT COUT 2 Instruction Bus [9:0] Control Signal ASM0406C FIGURE 1.2 : External ROM Map of ASM0406C PC[11:0] 12bit x 2 STACK 15-bit Data Pointer Reset Vector 00000h 00080h Reserved for Testing Program and data ROM 00080h-003FFh 00400h 00000h-00FFFh 00000h-03FFFh 00FFFh(4K) Data ROM 03FFFh(16Kx10-bits) 3 ASM0406C 1.2 Pin-Out ASM0406C Pin-Out VDD PRA3-1 PRA0/RESET I I/O Power supply during operation STI I/O port with programmable strong pull-low or weak pull-low or Std./O.D. fix-input-floating capability Output type with standard or Open-Drain output I/O STI I/O port with programmable strong pull-low or weak pull-low or Std./O.D. fix-input-floating capability Output type with standard or Open-Drain output Mask option selected as an external RESET pin with weak pull-low capability I RM mode Oscillator input O Current Output of Audio I Circuit Ground Potential O Enter Test Mode. ( TEST = High ) O Std./O.D. Output type with standard or Open-Drain output OSC COUT GND TEST PRB0-1 1.3 Application circuit 4 ASM0406C 1.4 Bonding Diagram 16K x 10 bit ROM Y= 1360+80(um) 1 2 3 4 5 6 7 8 ASM0406C CHIP SIZE: X= 1550+80(um) , Y= 1360+80(um) 11 10 9 X= 1550+80(um) Substrate must be connected to GND. ASM0406C Pad Location PAD # PAD Name 1 RA3 2 RA2 3 RA1 4 RA0 5 OSC 6 GND X -664.92 -664.92 -662.64 -468.24 -281.04 -111.72 Chip Size: X= 1550 + 80 (um), Y=1360 + 80 (um) Y PAD # PAD Name X Y -275.52 7 TEST 105.44 -600.2 -403.64 8 COUT 303.96 -600.2 -600.2 9 VDD 683.04 -600.2 -600.2 10 RB0 664.92 -399.2 -600.2 11 RB1 664.92 -280.8 -600.2 5 ASM0406C 1.5 DC Characteristics for ASMxxxxx SYMBOL VDD Isb Iop Iih Ioh Iol Cout dF/F dF/F PARAMETER OPERATING VOLTAGE SUPPLY CURRENT STANDBY OPERATING VDD 3 5 3 5 3 5 5 3 5 3 5 3 5 -10 -20 MIN. 2.4 TYP. 3 MAX. 5.0 1 1 UNIT V uA mA uA CONDITION depending on Freq. 4MHz, RM in HALT Mode 4MHz, RM IO Floating 4MHz, RM in HALT Mode (IO Ports with weak pull-high pull-low) INPUT CURRENT /Internal pull low OUTPUT HIGH CURRENT OUTPUT LOW CURRENT DA CURRENT OUT (FULL SCALE) FREQUENCY STABILITY Fosc VARIATION 2 7 3 9 -5.2 -3 -8 7 20 4 5.2 10 20 mA 4MHz, RM (IO ports) % % Fosc(3v- 2.4v) Fosc (3v) VDD=3V, Rosc=850k, 4MHz FIGURE 1.3 : Frequency Range for Rosc in RM mode Resistor(k ohm) 3v Freq.(MHz) 1200 2.92 1000 3.51 R osc & F req. 8 7.02 Freq. MHz 6 4 2 0 0 200 400 600 800 1000 1200 1400 R osc k ohm 4.13 3.51 2.92 820 4.13 560 7.02 6 |
Price & Availability of ASM0406C
 |
|
|
|
|
All Rights Reserved © IC-ON-LINE 2003 - 2022 |
| [Add Bookmark] [Contact Us] [Link exchange] [Privacy policy] |
|
Mirror Sites : [www.datasheet.hk]
[www.maxim4u.com] [www.ic-on-line.cn]
[www.ic-on-line.com] [www.ic-on-line.net]
[www.alldatasheet.com.cn]
[www.gdcy.com]
[www.gdcy.net] |